Search results

Installed the Auxbeam RGB AS-R40 switch panel. Wanted to install my Gatekeeper steering light mounts but didn't want to install another wire harness kit. Ripped out all my old wiring to the other lights and hooked them up to the switch panel. Wish I would of done this sooner. Didn't get to...

Was it originally from NJ? Like @WSS said the underside looks good rust wise. You can take the hardtop off or just the freedom panels if you don't have room for the whole top. Miles are high so guessing mostly if not all are highway mikes. How does the inside look? $13,000 isn't a bad price even...

If memory serves me right, I think I replaced my breather hoses with 3/8" rubber fuel line. I ran the front into the engine bay and mounted on the firewall. The rear I ran up and behind the taillight.

🤤 what size did you go with?

Does yo mamma's house allow you to spend a certain amount of money to show you tried to fix the issue(s) and give you a pass for the emissions testing? They do that here in PA.

Ouch!

I've had no problem with my plastic cap.

Yeah. The oil temp sensor crapped out 2 weeks later and threw a check engine light.

I got the same. Doorman was on backorder when I needed 1. I do recommend if your OEM sensors still works, use it.

Damn

You could always move your Midland over to the passenger side of the center and mount the switch where your Midland was?

Looks like the molding process to me. Mine had similar casting marks on it. No issues after 20k miles, "knock on wood".

In between unboxing donations for my Go Topless Day event and work, I did find some time to give my faded plastic some attention. I tried something new. Got it from Amazon. https://www.amazon.com/dp/B07SHJVK4G?tag=wranglerorg-20 Here's some before and after pictures. We'll see how it holds up!

I do have chimes for everything else

Wonder why mine doesn't chime

Damn. Mine doesn't chime. Just a visual on the dash.

Did anyone replace your u-joints on the drive shalf? I see you replaced them on both sides. Assuming youre talking about the front axle? I had a problem with a grind/squeak last year. Found out my needle bearings in the cap of 1 of the u-joints on the rear of my drive shaft was wasted. My buddy...

Have you tried to reset your oil life by turning the key to on but do not start the Jeep, within 10 seconds, press the gas peddle 3 times and turn the key to off. Turn key back on and check oil life again.

Didn't do anything to my Jeep lately. I've been busy getting sponsors to donate for my silent auction table. I'm going to be hosting a Barricade Go Topless Day event in Central Pennsylvania if anyone is interested. So far Rough Country, Rhino USA, Stoner Car Care, and Barricade donated for my event.

Was this a defect? Was the rim loose? Was the rim not seated the whole way flush against the spacer? Are the other spacers like this? Do the spacers have Loctite on the OEM studs? If I couldn't 100% answer these questions, I'd get all 4 replaced.