Recent content by yesterdaysbiscuits
-
Y
Limp Mode Help
Fixed: It was 5v reference codes that was caused by a corroded wire in the oil pressure connector switch that was caused by the oil cooler failing and leaking. This part is made of plastic and fails on the reg in 3.6 penstars . It was drawing engine coolant into the oil cooler and leaking...- yesterdaysbiscuits
- Post #4
- Forum: JK General Discussion
-
Y
Limp Mode Help
I'll try replacing the battery clamps All the grounds that I can find are clean ECM reset didn't help I used O'Reilly's sensors- yesterdaysbiscuits
- Post #3
- Forum: JK General Discussion
-
Y
Limp Mode Help
LIMP MODE HELP! My daily driver...2014 stock JKU with 103,000 miles is stuck in limp mode. It happened while doing about 50 miles per hour Sunday morning. On Saturday the CEL came on and the code came back for the Cam Shaft Sensor so I replaced it and drove about 30 miles but the light never...- yesterdaysbiscuits
- Thread
- Replies: 8
- Forum: JK General Discussion