Recent content by MARROBLET

I had the same size on my stock 2015. No problems except a little tire rub at full steering to the left. I just added a couple of washer behind the steering stops.

I just had new tires installed and an front alignment done on my 2015 JK Wrangler Willys.. The left camber is out of spec at -0,8 degrees. They told me there is no adjust for the camber. They said they would need to replace the ball joint with an offset one or possibly sleeve the current ball...

had a few patch. No problems. They patch from the inside.

you could try a couple of washer on the steering stop

Really no one has an opinion???

I have a stock 2015 JK Willys 2dr, except for 285/70 17 tires (33 vs 32). I planning on adding a Meyer HomePlow Basic Snow Plow 23250/ Curt front receiver 31432 this winter. Does anyone have this setup? How is working for you? My concern is Meyer says the hitch height needs to be 10" - 13" from...

I want to run lower tire pressure then the recommended 37 psi. How to I tell the TPMS that 30-32 psi is normal so the low tire pressure warning does not come on?

https://www.quadratec.com/products/12015_1009_07.htm

Is there a front bumper with a 2" hitch receiver? I am planning on adding a Snowsport plow on my 2015 JK. I know I can add just a front hitch mount, but would like to update the stock bumper. Is there any other affordable hitch mounted plows I should look at? I will only be using the plow for...

Check this hitch. No need to remove the bumper. It has welded nuts in the rear and you insert the bolts from the front. https://www.quadratec.com/products/12015_1009_07.htm?gclid=EAIaIQobChMIqYuO9q3k7QIVwdrICh3nkgziEAQYAyABEgJks_D_BwE