Recent content by Joey

No I got the transmission pump replaced and everything back together and it still would not move. Had it towed to a shop and they say I need a new transmission now which is over $4600. So I'm thinking I'm going to bring it back home put one in myself and save a little money.

I was able to get it out with a gear puller. Got the new pump in and everything is back together. Started it up and there was a noise like it was super tight and it died. Any ideas?

I was able to get the transmission back out yesterday and was told I need to replace the front pump. Any ideas on how to get it out? I have pulled the 5 bolts in it.

Ok thank you for the help I will pull the transmission back out and go from there.

Cleared the codes unhooked the line and nothing is coming out.

I will try the trans cooler line and see what happens. Yes I did the filter too.

Yes the jeep was fine before the install. The torque converter was slid all the way in and lined up as far as I could tell. It starts right up and no funny noise

I was able to get 2 quarts in the converter before I put it in. The fluid in N is showing full. I looked at all of the electrical connections and don't see anything wrong. It's now throwing a P0944.

Looking for help. I just replaced the torque converter in a 2011 Rubicon unlimited. Now the jeep will not move. The dash shows it is shifting and I can look on the side of the transmission and also see its shifting. Messing with the fluid is not working. I removed some fluid then made sure it...